rock crusher parts crusher mills cone crusher jaw crushers

Use of Crushed Granite Fine as Replacement to River

2013-8-11  The use of crushed granite fine to partially replace Makurdi river sand in concrete production will require a higher water to cement ratio, when compared with values

VALLUR,PRAKASAM(Dt).

2017-10-23  Crushed waste ceramic tiles, crushed waste ceramic tile powder and Granite powder are used as a replacement to the coarse aggregates and fine aggregate. The

Structural Behaviour of Crushed Fine Ceramic Tiles as ...

2021-3-1  ordinary mixes like M15 and M20. [18] used crushed waste tiles and Granite powder were used as a replacement to the coarse aggregates and fine aggregate. The

Partial Replacement of Aggregates with Ceramic Tiles

2018-6-15  The crushed tile aggregate passing through 16.5mm sieve and retained on 12mm sieve are used. Crushed tiles were partially replaced in place of coarse aggregate

AN EXPERIMENTAL STUDY ON PARTIAL REPLACEMENT

2021-2-27  Vol-3 Issue-5 2017 IJARIIE-ISSN(O)-2395-4396 6746 ijariie 1070 AN EXPERIMENTAL STUDY ON PARTIAL REPLACEMENT OF CRUSHED SPENT FIRE BRICKS AS FINE AGGREGATE

An Experimental Study on Partial Replacement of Sand

2016-3-3  Ordinary Portland cement of 43 grade conforming to IS 8112 was used throughout the work. The fine aggregate used in this investigation was clean river sand, whose

Incorporation of Waste Glass Powder as Partial

2016-9-9  A crushed granite rock with a maximum size of 20mm was used as coarse aggregate. Natural sand from Swarnamukhi River in Srikalahasti was used as fine

Partial Replacement of Fine Aggregate by Glass Powder in ...

2020-2-22  Fine aggregates will be replaced by waste Limestone powder as 5%, 10%, 15%, 20% and 40% weight for M-20 mix. The concrete specimens will be tested for compressive strength

Choice Of Quarry Rock Dust Over Natural Sand As Fine

1 Replacement of fine aggregate by quarry dust at partial replace results the increase in strength of concrete 2 The concept of replacement of natural fine

Evaluation of sulfate resistance of cement mortars with ...

2021-7-13  The crushed aggregate was used as a fine aggregate with a fineness modulus of 2.71, specific gravity of 2.57, an absorption rate of 1.49%, and the volumetric percent

Partial Replacement of Aggregates with Ceramic Tiles

2018-6-15  The crushed tile aggregate passing through 16.5mm sieve and retained on 12mm sieve are used. Crushed tiles were partially replaced in place of coarse aggregate by the percentages of 10%, 20% and 30%, 40% and 50% individually and along with replacement of fine aggregate with granite powder also. 2.1.6 CERAMIC TILE-FINE AGGREGATE:

AN EXPERIMENTAL STUDY ON PARTIAL REPLACEMENT

2021-2-27  Vol-3 Issue-5 2017 IJARIIE-ISSN(O)-2395-4396 6746 ijariie 1070 AN EXPERIMENTAL STUDY ON PARTIAL REPLACEMENT OF CRUSHED SPENT FIRE BRICKS AS FINE AGGREGATE R.Subramanian1, K.KalaiPandian2, R.AmuthaSelvaKumar3 1PG Scholar, Department of Civil Engineering, Sri Vidya College of Engineering Technology, VNR, TN, India.

An Experimental Study on Partial Replacement of Sand

2016-3-3  Ordinary Portland cement of 43 grade conforming to IS 8112 was used throughout the work. The fine aggregate used in this investigation was clean river sand, whose maximum size is 4.75 mm, conforming to grading zone II. Machine crushed blue granite stone angular in shape was used as coarse aggregate.

Incorporation of Waste Glass Powder as Partial

2016-9-9  A crushed granite rock with a maximum size of 20mm was used as coarse aggregate. Natural sand from Swarnamukhi River in Srikalahasti was used as fine aggregate. The fineness modulus is 5.77 for fine aggregate and for coarse aggregate is 7.18 conforming to zone- II of IS 383-1970 [10].The specific gravity of aggregates is presented in Table. 2.

Dolomite rock sand as fine aggregate replacement in ...

2021-1-1  This paper attempts to study the use of dolomite rock sand (DRS) as fine aggregate replacement to crushed sand considering the increasing demand from construction industry and depleting crushed sand availability, in this regard DRS as fine aggregate (FA) replacement might be a

Study of Strength and Workability of Different Grades of ...

2020-4-17  the crushed stone aggregate. In spite of its extensive use and ... specified sizes for use as aggregate in various applications such as water filtration; girt plastering, sand cover for sport ... Study of Strength and Workability of Different Grades of Concrete by Partial Replacement of Fine Aggregate by Crushed Brick and Recycled Glass Powder ...

STUDY OF STRENGTH CHARACTERISTICS OF CRUSHED

2019-4-21  crushed Limestone as partial replacement of fine aggregate by using mix proportion of 1:1.5:3. The casting of cubes and cylinders are removed from the mould after 24 hours then they were immersed into the curing tank before the testing like 3,7,14,28,56,90 days in order to obtain the strength of concrete.

Study on Compressive Strength of Quarry Dust as Fine ...

2016-7-28  The concept of replacement of natural fine aggregate by quarry dust which is highlighted in the study could boost the consumption of quarry dust generated from quarries. By replacement of quarry dust, the requirement of land fill area can be reduced and can also solve the problem of natural sand scarcity. The availability of sand at low cost as a fine aggregate in concrete is not suitable and ...

EFFECT OF FLY ASH AND QUARRY DUST AS A PARTIAL

2018-11-5  aggregates generally consist of natural sand or crushed stone. Medium and fine sand are to be used in mortars. The properties of fine aggregate shall be in accordance with the requirements of IS: 383-197 The compressive strength, crushing value, etc. of the aggregate shall be in accordance with the requirements of IS: 383-1970

Fine Aggregate: Definition, Size, Density and Properties ...

Fine aggregate is the essential ingredient in concrete that consists of natural sand or crushed stone. The quality and fine aggregate density strongly influence the hardened properties of the concrete.. The concrete or mortar mixture can be made more durable, stronger and cheaper if you made the selection of fine aggregate

Use of Crushed Granite Fine as Replacement to River Sand ...

2013-8-11  The use of only Makurdi river sand as fine aggregate and gravel to produce grade C 35 concrete will cost N 16,559 a value lower than N 16,580 and N 16,622 obtained with the use of Makurdi river sand partially replaced with 10% and 30% crushed granite fine respectively.

Structural Behaviour of Crushed Fine Ceramic Tiles as ...

2021-3-1  ordinary mixes like M15 and M20. [18] used crushed waste tiles and Granite powder were used as a replacement to the coarse aggregates and fine aggregate. The combination of waste crushed tiles were replaced coarse aggregates by 10%, 20%, 30% and 40% and Granite powder was replaced fine aggregate by 10%, 20%, 30% and 40% without changing the

Partial Replacement of Fine Aggregate by Glass Powder in ...

2020-2-22  Fine aggregates will be replaced by waste Limestone powder as 5%, 10%, 15%, 20% and 40% weight for M-20 mix. The concrete specimens will be tested for compressive strength at 4, 7 and. 28 days respectively and also the results obtained will be compared with those of traditional concrete. Glass powder (GP) utilized in concrete creating ends up in ...

An Experimental Study on Partial Replacement of Sand

2016-3-3  Ordinary Portland cement of 43 grade conforming to IS 8112 was used throughout the work. The fine aggregate used in this investigation was clean river sand, whose maximum size is 4.75 mm, conforming to grading zone II. Machine crushed blue granite stone angular in shape was used as coarse aggregate.

AN EXPERIMENTAL STUDY ON PARTIAL REPLACEMENT

2021-2-27  Vol-3 Issue-5 2017 IJARIIE-ISSN(O)-2395-4396 6746 ijariie 1070 AN EXPERIMENTAL STUDY ON PARTIAL REPLACEMENT OF CRUSHED SPENT FIRE BRICKS AS FINE AGGREGATE R.Subramanian1, K.KalaiPandian2, R.AmuthaSelvaKumar3 1PG Scholar, Department of Civil Engineering, Sri Vidya College of Engineering Technology, VNR, TN, India.

Dolomite rock sand as fine aggregate replacement in ...

2021-1-1  This paper attempts to study the use of dolomite rock sand (DRS) as fine aggregate replacement to crushed sand considering the increasing demand from construction industry and depleting crushed sand availability, in this regard DRS as fine aggregate (FA) replacement might be a

Choice Of Quarry Rock Dust Over Natural Sand As Fine

1 Replacement of fine aggregate by quarry dust at partial replace results the increase in strength of concrete 2 The concept of replacement of natural fine aggregate sand by quarry dust may help in many ways such as it is helpful to control environment pollution erosion of river bank might stop and also the waste quarry material can be. Read More.

Utilization of Stone Dust as Fine Aggregate Replacement

Concrete of M25 grade was designed for a w/c ratio of 0.48 for the replacement of 10% coarse aggregate with recycled coarse aggregate and replacement of 50, 60 and 70% of fine aggregate (sand ...

(PDF) THE USE OF WASTE GLASS AS FINE AGGREGATE

Two replacement contents are investigated: 15% and 30%, replacing fine aggregate by volume. The results show that plastic, rubber and Limestone decrease concrete workability, and increase air content ...

EFFECT OF FLY ASH AND QUARRY DUST AS A PARTIAL

2018-11-5  aggregates generally consist of natural sand or crushed stone. Medium and fine sand are to be used in mortars. The properties of fine aggregate shall be in accordance with the requirements of IS: 383-197 The compressive strength, crushing value, etc. of the aggregate shall be in accordance with the requirements of IS: 383-1970